The Ultimate 2.4GHz CPE for the Global WISP Community
Featuring Adaptive Antenna Polarity (AAP) Technology.
Flash Ubiquiti NS2 to DD-WRT v24
Requirements:
- Direct ethernet cable connection between PC and LiteStation
- Network settings of PC: 192.168.1.254/255.255.255.0
- TFTP client on PC
- LiteStation firmware file (e.g. NS2.dd-wrt.bin for LiteStation5)
Flashing procedure:
- Please ensure that the latest firmware revision of Ubiquiti is already installed using the web upgrade utility (e.g.V 2.1.9)
- If not, please reflash it using the Ubiquiti NS2 Web interface. This is important to ensure that the latest RedBoot Bootloader
- is installed.
- power off the device and power it on again while holding the reset button for about ~10 seconds
- flash NS2.dd-wrt.bin using tftp to 192.168.1.20 in binary mode
- windows : tftp -i 192.168.1.20 put NS2.dd-wrt.bin
- linux/unix/macosx: tftp 192.168.1.20
- tftp> bin
- tftp> put NS2.dd-wrt.bin
- tftp> exit
- Atheros AR2315 SOC, MIPS 4KC, 180MHz
- 16MB SDRAM, 4MB Flash
- 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
- FCC Part 15.247, IC RS210
- Yes
- 26dBm, +/-2dB
- -97dBm +/-2dB
- Integrated 10dBi Dual Pol + External RP-SMA
- over 15km
- 25Mbps+
- 5 Watts
- 12V, 1A (12 Watts). Supply and injector included
- Passive Power over Ethernet (pairs 4,5+; 7,8 return)
- -20C to +70C (System PCB optimized for hi-temp)
- 5 to 95% Condensing
- ETSI300-019-1.4
- 0.4 kg
 Technology. Fla...){kind=link}